opamptester.zip rendering result

Renderings are for reference only, please don't write about problems.

opamptester.zip gerber layer report

Size check

Maximum board length and width must be equal to or less than the ordered length and width. Even one mm bigger than the ordered size is TOO LARGE and your order will be canceled or delayed. Please note that Protopacks are sold by maximum length and width dimention, not area. A 2x7cm PCB fits a 10x10cm Protopack, it does not fit a 5x5cm Protopack.

Our measurement script can be thrown off by a lot of things like components or text outside the PCB, especially on the board outline layer. If you're sure the board fits in the size purchased you may ignore this warning

Status Order size Measured size
OK 5.0cm x 6.0cm 5.0cm x 6.0cm

Board Outline

The board outline layer contains an outline of the PCB area and slots to be milled. It should have an extension like .gml/.gko/.gbr. A board outline is required.

Status Layer Extension File Error
OK Board Outline (.GBR) gbr OPAMPTESTER.gbr

Drill File

A drill file contains the size and location of holes on the PCB. A drill file is generally required, but if you purposly omitted it then you can ignore any warnings.

Status Layer Extension File Error
OK Drill File (.TXT) txt OPAMPTESTER.txt

Top

The top layer of the PCB generally has a silk screen, solder mask, and copper trace layer. If you intentionally omitted one of these layers you may ignore any warnings.

Status Layer Extension File Error
OK Top Overlay (Silkscreen) gto OPAMPTESTER.gto
OK Top Soldermask gts OPAMPTESTER.gts
OK Top Layer (Copper) gtl OPAMPTESTER.gtl

Bottom

The bottom layer of the PCB generally has a copper trace layer, solder mask, and silk screen. If you intentionally omitted one of these layers you may ignore any warnings.

Status Layer Extension File Error
OK Bottom Layer (Copper) gbl OPAMPTESTER.gbl
OK Bottom Soldermask gbs OPAMPTESTER.gbs
OK Bottom Overlay (Silkscreen) gbo

PCB Help