Drop-in firmware replacement board for Kinesis Advantage ergonomic keyboards. Firmware and schematics available at https://github.com/chrisandreae/key...
This is a set of basic breakout boards for using common size SMD components on a breadboard. This board is actually 6 pieces panelized together. You...
Daughterboard to replace four 4164 by a 256k x 4 (example: HYB514256B) DRAM on a Commodore64(8 ram chips unit).
The pcb slik markings represente the ...
A pomodoro timer featuring a capacitve touch button, PWM-driven LEDs and a piezo buzzer. Based on the Pomodoro project by Robin Scheibler (github: Fak...
Board to mount a servo under a Marklin C Track switch and at the same time be a decoder for the Motorola accessory protocol. The decoder supports two ...
This is a Beaglebone cape mixing the EEPROM config chip board from Sparkfun with Seeedstudio Grove breakout board. Some Xadow system headers are also ...
0.14mm breakout. Up to 52 pins. Works with even- or odd-numbered connectors, just choose which outer side you want to use.
Also works with any pin co...
Board for an ATtiny13A and moisture sensor alarm. Ultra low power applications in power down mode allow running off a CR2032 coin cell for couple of y...
Breackout for dual use, PIC 16Fxxxx 14 pin and 18 pin chips.
It has 3 jumpers to select which type of PIC will be installed, for use with the ICSP he...
This is the PCB for a DIY Synth you can plug in a TEENSY3.1 with audio adapter board.
Read here for more info: http://randumbpage.wordpress.com/2014...
