GerberRGBWContrl.zip rendering result
Renderings are for reference only, please don't write about problems.
GerberRGBWContrl.zip gerber layer report
Size check
Maximum board length and width must be equal to or less than the ordered length and width. Even one mm bigger than the ordered size is TOO LARGE and your order will be canceled or delayed. Please note that Protopacks are sold by maximum length and width dimention, not area. A 2x7cm PCB fits a 10x10cm Protopack, it does not fit a 5x5cm Protopack.
Our measurement script can be thrown off by a lot of things like components or text outside the PCB, especially on the board outline layer. If you're sure the board fits in the size purchased you may ignore this warning
| Status | Order size | Measured size |
|---|---|---|
| OK | 5.0cm x 5.0cm | 3.0cm x 5.0cm |
Board Outline
The board outline layer contains an outline of the PCB area and slots to be milled. It should have an extension like .gml/.gko/.gbr. A board outline is required.
| Status | Layer | Extension | File | Error |
|---|---|---|---|---|
| OK | Board Outline (.GML) | gml | RGBWController-Edge_Cuts.gml |
Drill File
A drill file contains the size and location of holes on the PCB. A drill file is generally required, but if you purposly omitted it then you can ignore any warnings.
| Status | Layer | Extension | File | Error |
|---|---|---|---|---|
| OK | Drill File (.DRL) | drl | RGBWController.drl |
Top
The top layer of the PCB generally has a silk screen, solder mask, and copper trace layer. If you intentionally omitted one of these layers you may ignore any warnings.
| Status | Layer | Extension | File | Error |
|---|---|---|---|---|
| OK | Top Overlay (Silkscreen) | gto | RGBWController-F_SilkS.gto | |
| OK | Top Soldermask | gts | RGBWController-F_Mask.gts | |
| OK | Top Layer (Copper) | gtl | RGBWController-F_Cu.gtl |
Bottom
The bottom layer of the PCB generally has a copper trace layer, solder mask, and silk screen. If you intentionally omitted one of these layers you may ignore any warnings.
| Status | Layer | Extension | File | Error |
|---|---|---|---|---|
| OK | Bottom Layer (Copper) | gbl | RGBWController-B_Cu.gbl | |
| OK | Bottom Soldermask | gbs | RGBWController-B_Mask.gbs | |
| OK | Bottom Overlay (Silkscreen) | gbo | RGBWController-B_SilkS.gbo |